APRS Track Direct

My position About ☰

reset

W4KEL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*
1732318741	14.93	16.28
1732318721	14.84	16.28
1732318714	14.84	16.28
1732318709	14.93	16.28
1732318687	14.93	15.8
1732318662	14.9	15.8
1732318657	14.81	15.31
1732318646	14.99	15.31
1732318636	14.93	15.31
1732318609	14.87	14.83
1732318551	14.99	14.83
1732318527	14.87	14.35
1732318483	14.9	14.35
1732318477	14.87	13.86
1732318472	14.9	13.86
1732318456	14.81	13.86
1732318428	14.93	13.86
1732318393	14.93	13.38
1732318355	14.84	12.89
1732318313	14.93	12.89
1732318204	14.9	11.93
1732318193	14.87	11.93
1732318160	14.9	11.44
1732318147	14.96	11.44
1732318113	14.9	10.96

*Used Equation Coefficients:

Value1: 0, 0.0306, 0

Value2: 0, 0.484, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)