APRS Track Direct

My position About ☰

reset

W4KEL-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-7. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1732266097	13.42	9.49
1732264056	13.45	9.49
1732262016	13.42	9.49
1732259976	13.42	9.98
1732257934	13.42	9.98
1732255894	13.42	10.47
1732253854	13.42	10.47
1732251814	13.42	10.96
1732249773	13.42	10.96
1732247732	13.42	11.45
1732245692	13.42	11.94
1732243651	13.42	11.94
1732241610	13.42	12.43
1732239570	13.42	12.92
1732237529	13.45	12.92
1732233448	13.42	14.38
1732231407	13.42	15.36
1732229367	13.42	15.85
1732227325	13.45	16.34
1732225284	13.45	16.34
1732223243	13.39	16.83
1732221201	13.54	17.32
1732219160	13.57	17.32
1732217119	13.57	17.32
1732215077	13.65	16.83

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.489, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)