APRS Track Direct

My position About ☰

reset

DL0PCN-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL0PCN-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value3*	Value4*	Value5*
1732527322	4168	192	1354	8005
1732527158	4168	188	1355	8005
1732526994	4168	192	1354	8006
1732526830	4168	192	1353	8007
1732526666	4168	189	1351	8005
1732526502	4168	192	1351	8007
1732526338	4168	189	1350	8006
1732526174	4168	192	1351	8006
1732526010	4168	190	1351	8006
1732525846	4168	191	1350	8006
1732525682	4168	191	1351	8006
1732525518	4168	191	1350	8006
1732525354	4168	190	1351	8006
1732525026	4168	192	1350	8006
1732524862	4168	193	1350	8007
1732524698	4168	192	1350	8008
1732524534	4168	190	1351	8009
1732524370	4168	188	1350	8009
1732524206	4168	190	1350	8011
1732524042	4168	191	1350	8010
1732523878	4168	192	1350	8011
1732523714	4168	192	1350	8010
1732523550	4168	193	1350	8010
1732523386	4168	191	1350	8010
1732523222	4168	191	1351	8009

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)